Mitre a Picture Frame
Picture frames fit well-adjusted with tight, mitered angles glance fitter and grip up longer than other frames. For larger, bulky frames, mitered corners decrease a fleeting of the weight, creation it less possible that the frame Testament come apart over era nailed down the easy fury of gravity. Angles are even stronger as contact points. The against and stile interpretation common of theatre flats and window frames is not forcible when gravity is constantly pulling at the backside of the frame.
Instructions
1. Decide what dimensions frame you demand. Normally, the frame Testament be as insufficient as practicable while much becoming the photo or artwork. Forging the frame as minor as viable saves inventory and enhances the photo. A photo or collection of Craft in extremely great a frame can pass into dominated, lessening its visual impact.
2. Measure twice the length of each rail, which are the vertical pieces, and twice the length of each stile, which are the horizontal pieces. Place the rail piece in the miter box at the correct length for one rail and set your cutting angle. Place the back saw in the correct angle slot and begin cutting. Draw saw back across the wood, then push saw back and forth rapidly until it severs the wood.
3. Hammer tacks into each side, approximately where the center point of the top and bottom piece would be. It should not be necessary to hammer tacks from the top and bottom unless the picture will be particularly heavy. If the framing wood you are using is heavier than 1/2-by-2-inch stock, use correspondingly larger fasteners instead of 1/2-inch tacks.
4. Repeat Steps 2 and 3 to chop the two stiles. Place all four pieces so that the mitered corners are touching. Apply carpenter's glue to the mitered angles of each piece and allow the glue to dry until it is tacky. Push all four pieces together firmly. Use a C-clamp to hold the corners tight against each other until the glue dries overnight.
5. Use a tack hammer and brass finishing tacks to secure rails to stiles. Measure the two pieces you just cut to be sure they are identical. Sand away any burrs. Use coarse, medium, fine and extra fine sandpaper to give both pieces a smooth finish. For the largest stock wood, use wood screws with countersunk holes.
