You've looked into how all the more it fee to receive a learned blood dye duty for your vehivle, however you can’t afford it. You could always shop for the primer and emulsion yourself, and influence to chore.
Instructions
1. Thoroughly wash the motorcar to remove all dirt, means tar and other Non-native substances. Cause a indubitable gentle soap impression and rinse the vehivle diverse times until all the soap is out. Then dry the motorcar husky.
2. Encompass all surfaces that are not to be painted or shouldn't bias colouring on them with whatever counsel you hold chosen to call as protectant. This is called “masking." Avail as many layers as exigent, and secure the protectant flourishing so that emulsion cannot seep on ice or under the protectant.
3. Decide where on the automobile you are going to start illustration.
4. If necessary, fix any imperfections by filing or scraping down high places and bumps, then wet-sand the surface again, beginning with 300-grit paper and ending with 500 to 600 grit sandpaper.14. Repeat Steps 7, 8 and 9 to apply the second coat of primer. Allow this coat to dry for 48 hours.
Whether you are using a commercial (industrial) gloss sprayer, thin the automotive distemper primer according to the manufacturer's directions.
6. Provided you are using primer that is already in a spray paint can, skip Step 5.
7. Starting at the masking on one side and ending at the masking on the other side, spray the primer onto the area of the car you are painting first, using broad strokes. Work from the top down, going left to right, overlapping the strokes. Keep the nozzle about 8 to 10 inches from the surface as you apply the paint.
8. Wait about 30 seconds, and then repeat Step 7 on the same area.
9. Repeat Steps 7 and 8 until you have painted over the same area three or four times.
10. Repeat Steps 7, 8 and 9 until the entire car surface has been primed. Then allow the primer to dry for at least 48 hours.
11. Wet-sand all primed areas until the surface is completely smooth. Wet-sanding simply means you are using fine-grit sandpaper that has been soaked in water, then attached to a sandpaper “brick” or holder.
12. Use a clean, wet rag to remove any leftover sandpaper grit, and then dry the sanded areas thoroughly.
13. Check to see that the surface is perfectly smooth and even (no high places, bumps or other imperfections). Pour denatured or rubbing alcohol on a cloth or paper towel, and dust the entire surface of the sphere. This Testament make safe that all soap residue has been removed. Dry the surface with a cloth or paper towel, then own it to air-dry for a scarce minutes.5.
15. To prepare for application of the top coat (the red paint), repeat Steps 11 and 12.
16. After this, repeat Step 4.
17.Apply the paint using the same directions set out in Steps 7, 8 and 9.
