Preserve your flood colour Craft by sealing the surface with a UV-resistant clear-coat spray.
Glue the paper to a canvas for framing using a fluid-matte medium brushed on the back of the watercolor paper and the canvas. Press the two together to form the initial bond, then flip the canvas so the watercolor is face down. Press the rear of the canvas from the center outward to remove any air bubbles trapped between the canvas and paper. Place a piece of Plexiglass large enough to cover the watercolor on the back of the canvas over where the watercolor is attached, and then place several large books on the Plexiglass to weigh it down, aiding in the bonding process.
1. Country the paper watercolour representation on a Apartment lodgings surface that provides Sufficiently amplitude to effort. Daily grind in a dust-free globe to avoid dust settling on the sealant as it dries.
2. Shake a can of UV-resistant acrylic at liberty coat vigorously to blend the counsel and ice a smooth, all the more spray. Clout the clear-coat approximately six inches from the watercolour's surface, then spray the depiciton with a lambent coating, beguiling interest not to let the coating pool. Control your arm Stirring constantly back and forth to fabricate an even coat on the page without saturating the page. Allow the layer to dry for 30 minutes.
3. Apply two additional layers of clear-coat to the watercolor, following the same procedure. Allow each layer (except the last) 30 minutes drying time. Let the final layer dry overnight.
4.Sealing a watercolour representation on paper is a system to maintain the colours of the picture for decades and minimize fading from exposure to clear. A rare layers of a ultra-violent-resistant matte clear-coating properly applied provides Safeguard without altering the appearance of the representation as mounting extreme UV-resistant glass might. After spraying, the picture is ready for mounting and framing, with the clear-coat providing Safeguard from bright and physical damage.
Instructions
Leave the weights in place for two hours.5. Remove the books and the Plexiglass. Flip the canvas over and wipe away any of the matte medium that squeezed from between the paper and canvas with a piece of cloth. Allow the paper to dry in place overnight.
6. Use a paintbrush to apply two coats of a gloss-varnish mixture on the canvas and watercolor. The varnish should be mixed with three parts varnish to one part matte medium, with a little water added for smoothness,
