Build a doll chest of drawers outside of a box.
Folded paper drawers can turn a inconsequential box into a doll's Tall-boy. A great box that is approximately as far as it is Broad can be fictional into a pretty diminutive chest by standing it up and filling it with diverse paper drawers. Glue a petty round bead to the front of Everyone for a drawer pull. It would be exceptionally perky with each drawer specious in a disparate relevant colour.
Instructions
Folding the Drawer
This will bring the bottom of the box straight up and form the third side.10. Rotate the box 180 degrees and repeat the previous step.11.
Fold the paper in half by bringing the two inverse sides of the paper calm, matching corners. Crease exclusive the edges of this fold. Build single petite, 1/2-inch creases and then unfold.
3. Turn the paper 90 degrees and fold the paper in half the corresponding course of action. Compose matchless mini creases on the edges and unfold.
4. Fold all four corners into the centre, using the creases you made previously as a counselor. You Testament anatomy another square.
5. Fold the top border down and the backside line up until they proper in the centre. Crease these folds sharply and unfold.
6. Turn the paper 90 degrees and repeat the preceding fold.
7. Unfold the top and backside flaps.
8. Fold the sides in along the inner folds you mythical previously. Crease sharply and unfold to 90 degrees. They should be standing straight up. These are the sides of your box.
9. Grab the top edge of both sides, one in each hand and bring them together.1. Abode a square plenty of paper right-side up on a table. The paper should be three times the broadness of the box minus1/2 inch.2.
Lay the box down and fold the two flaps which are sticking up down into the box.
Assembling the Chest.
12. Cut a piece of paper into two strips (three if you made four drawers) each one inch wider than the box and as deep as the box. Make a crease 1/2 inch from each side of the width. Fold the creased ends up so they are at a 90-degree angle to the paper. Glue each paper into the box along these tabs to serve as drawer separators.
13. Stand the box up so it opens toward the front. Stack the drawers inside, each on top of a drawer separator. If there is a gap at the top cut several sheets of cardboard to fit the bottom of the box and place the drawers on top. Add cardboard until the gap is filled.
14. Glue small round beads on the front of the drawers for handles if desired.
