Eaves are the undersides of roof edges.
An eave is the roof limit's underside, and it may be disclosed or enclosed with soffit creating a horizontal plane, giving the eave a finished gander. The magnitude of desired roof overhang determines where you intersect the rafter tails when finishing away this roof existence. Overhangs play a role in directing rainfall absent from the foundation, so don't intersect the eaves besides short.
Instructions
1. Country one cusp of a measuring tape against the box's side below one of the rafters on the roof's far side. Extend the tape's other bound horizontally outside to equitable the rafter's backside column.
3. Brew a moment aim in the twin operation on the far rafter on the antithetical side of the roof.4. Impel two 6d or companion bigness nails approximately 1 inch directly into the aim on Everyone rafter from the underside.
2. Construct a pencil speck on the rafter's backside contour 1 1/2 inches shorter than you yearning the overhang. For instance, a criterion overhang is 24 inches, so aim the rafter at 22 1/2 inches. The 1 1/2 inches is for installing subfascia, which is considered as any of the overhang.
The Spike heads should extend downward. Analysis the distance from the nails to the side of the house ensuring that both nails are exactly the same distance from the siding.
5. Snap a chalk line on the rafters' undersides between the two nails. This marks the undersides of all the rafters in between.
6. Hold a carpenter's level along the side of every rafter aligned with the chalk line. Make a pencil line alongside the level from the top to the bottom on one side of each rafter. This is the cut line.
7. Verify that the cut lines on the rafters are vertical and even by driving a nail into the top of the outside rafter at the top of the cut line. This is similar to what you did with first chalk line, only the nails are on the top of the rafters this time.
8. Place a regular string taut between the nails and check each rafter making sure the individual cut lines line up with the string at each rafter's top.
9. Cut off the rafter's ends along the cut lines with a circular saw. Cutting from the top down prevents the rafter's bottom part from pinching the saw blade.
