A frame can be both decorative and functional.
Frames support protect and add to artwork. Useful Craft without a decorative path can inspect bland and unappealing. The certain edges of the frame further avail control the structural candor and shape of the artwork.
Flat Artwork
4. See the edges of the artwork to dispose how even extension you can devote to the frame. For instance, impel whether you can divide a half-inch off each side of the image without ruining the integrity of the design.Instructions
Raised Canvas Paintings
1. Levy your picture frame face down on a Apartment lodgings surface. Apartment the canvas face down inside the frame.
2. Abode indemnify clips (stooped clips that adhere the frame to the canvas) on the edges of the frame with the screw gap resting on the frame. Deposit the clips on the top and the backside of the frame, 2 inches from the corners. Position the solid speck of the clips (the extremity without a screw gap) over the borderline of the canvas.
3. Drill short screws into the frame ended the gap in the stooped clips. Tighten the clips down so they don't rotate under the screw. The clips Celebrate the canvas on the back in lay while the lip at the front of the frame keeps it from falling forward.
Not all frames are Identical, though. Choose your frame carefully depending on the shape of your artwork also as the medium. For instance, a raised canvas needs a Numb frame that Testament sit comfortably on all sides of the edges of canvas frame while Apartment lodgings artwork such as photography can employ a yet simpler frame.
Draw a faint pencil line around the edges as a reminder of where your frame should sit.
5. Cut a square out of a piece of mat board. The square should be the size of the artwork after you subtract the distance of the outer edges.
6. Cut four pieces of tape 2 inches in length. Bring the edges of the tape together, forming a tape loop with the sticky side on the outside.
7. Press the tape loops flat on an uncut piece of mat board that is at least 3 inches longer on each side than your artwork. Position the loops so they will sit where the outside edges of the artwork sit against the mat board.
8. Press the tape loops flat on an uncut piece of mat board that is at least 3 inches longer on each side than your artwork. Position the loops so they will sit where the outside edges of the artwork sit against the mat board.
9. Set the cut piece of mat board on top of the artwork. Line up the edges of the frame with the lines on the artwork. Press the corners down to make the putty bind the front piece of mat board to the back piece.
