Figure a frame for your artwork
Manufacture your own wooden frames away of molding is an inexpensive road to discover a frame for an artwork. It as well provides the befalling to custom plot the type of frame you be convinced first-rate suitable for the parcel of Craft that you wish to demonstrate. Building a frame requires patience, a uncommon tools, and a hardly any basic woodworking skills. By reason of molding is inexpensive don't keeping whether it part a couple of times to blameless your procedure.
Instructions
1. Fix up a grind field.3. Select the wooden molding for the frame. Moulding sold at art supply stores or framing stores already has the rabbet cut that makes it easier to fit the sides together.
Degree the matting with a ruler or tape degree and add 1/8 inch to Everyone side. This Testament be the measurement for the frame. Degree from the top left corner to the backside right corner and then measure from the top right corner to the bottom left corner. If the matting is square the two measurements are equal.
Situate the the matting for the artwork on the commission bench. Fix up the basic tools very such as a mitre box, backsaw, C-clamp and corner clamps. A mitre box is a basic woodworking stuff used to clinch wood in habitat as it is duration abbreviate and worked on.2. Purchase moulding that corresponds the measurements for the matting. Use your own discretion and taste to determine the width of the moulding.
4. Attach one piece of the moulding to the miter with a C-clamp. Place a scrap of wood on the rabbet side of the moulding. The C-clamp should not touch the muolding. Cut the corner at a 45 degree angle with a backsaw. Repeat the procedure for the remaining sides.
5. Assemble two adjoining sides, the bottom and the left side, together in a corner clamp. Use a scrap of wood in between the clamp and the moulding. Secure the two sides with wood glue. Wipe off excess glue with a damp cloth. Leave the two pieces clamped together and repeat the procedure with the top piece and right side using a different corner clamp.
6. Tap in the wire brads while the glue is still wet. Drill pilot holes in each of the corners and tap the wire brads into the moulding with a tack hammer.
7. Assemble the two L-shaped pieces of the frame together. Fit the corners together and hold them in place with corner clamps. Fill the corners with wood glue. Wipe off excess glue and secure the moulding with wire brads. Allow the glue to dry thoroughly.
