Whether you don't hog a research press or an etching press for forming prints, pop using a slab curler. Although these rollers are intended to roll absent slabs of clay for ceramics Industry, you can too exercise them to assemble endowment linoleum block and wood engraving prints. Provided you chalk up access to a ceramics studio, using a slab curler for printmaking is not difficult. You'll pull an filled edition of prints in the corresponding clock it would gate on a probation or etching press.
Instructions
7. Print a final proof on the paper you intend to use for your edition of prints and check the image impression once more.8. Make any final adjustments to the level of ink you apply to your block and to the height of the slab roller cylinder and begin printing your edition.
2. Deposit a dollop of printing ink on a plenty of glass or marble and distribute it with a rubber brayer.
3. Load the brayer with a coat of ink and spread an yet layer over the surface of a linoleum block or wood engraving that measures no taller than 2 1/8 inches.
4. Compass the inked block face-up on the slab roller and position a piece of scrap paper on the block.
5. Turn the slab roller's large wheel to run the block and scrap paper under the cylinder.
6. Check the image impression. If the impression looks light, slightly lower the cylinder height and repeat the proofing process described above.
1. Adjust the slab curler so the cylinder sits as high-reaching off the rolling surface as feasible. Depending on the pattern, the slab curler's cylinder should sit approximately 2 1/4 to 2 3/4 inches above the rolling surface.
