There are many times when a current fret must be installed on a guitar. The guitar may corner at sea a fret, or the existing frets may be worn. There are and those who fancy production their own guitars. To install a brand-new guitar fret, many human beings utilize a fret press for a able installation.Fret Press Installation
4. Place the end of the fret into the correct slot on the neck.
Degree the span needed for your frets. Shorten the fret to the length you gain measured.
2. Cause a fret hammer to install your frets. Hammer the extreme of one fret into the neck. The fret hammer should be used gently to avoid splitting the neck. Hammering dependable the end into the neck will hold it in place for remainder of the installation.
3. Slide remainder of the fret into a straight line from the point that it's already been attached. Hammer remainder of the fret lightly into place.
However a fret hammer can profession dispassionate too.
Instructions
Manual Installation
1.Hold it at an angle so that only one end of the fret is touching it.
5. Take the fret press and hold it over the fret. Make sure that the fret lines up in a straight line with the slot.
6. Press down with the fret press. The pressure should be applied slowly until the fret press will not lower any longer. Leave the full pressure on the fret for a second or two.
7. Remove the fret press and check the fret to make sure it's firmly attached. Install any other frets in the same manner.