Monday, August 31, 2015

Understand Studio Lighting

Working with studio lights is a fine method to memorize.


To the uninitiated, a photo studio may be a actual intimidating field. With the altered type of studio blaze, backdrops, reflectors and it can be onerous to perceive where to position them to accomplish the consequence you are looking for. Studio lights chalk up a Broad scope of dynamism settings that when used true Testament devise lucent that is beefy balanced, or by varying the ability of the lights, you can assemble bounteous dramatic lighting. Kind studio lighting does revenue some participation, on the other hand with a diminutive bit of test and misconception, photographers quickly be trained how basic it is to benefit studio lights and ascendancy them for the prime practicable carved figure.


Instructions


Position the reflector in front of the stool and angle it towards the ceiling. This will "bounce" or "reflect" light from the three strobes back up towards your model, creating a nice soft fill under the model's chin. Position the reflector so it is not in the picture. A reflector is made of lighter color material or board that will reflect light back towards your subject.6. Mount the camera to the tripod, plug in your synchronization cord, turn on the three strobes, meter the camera exposure to match the main light and you are ready to start shooting. Using a camera mounted on a tripod not only reduces camera shake, it also helps in knowing where to position the camera relative to your lighting set up.



2. Position your main light at a 45-degree angle on either the right side or left side of the stool. Set the light to full power. If you are using strobes versus constant lights turn on the model light, also at full power


3. Position your fill light (also known as second light) at a 45-degree angle on the opposite side of the stool from your main light. Set the light to half power. And if you are using strobes turn on the model light, at half power. This is a standard 1:2 ratio used in most basic lighting setups. It will create a slight shadow on one side of the models face. It is important that the two lights be an equal distance and angel from the stool. Between 2 feet and 4 feet is a good distance.


4. Position the third light directly above the stool so it will be high enough to illuminate the top of your models head. This is known as a "hair light" and should be set at the same power as your fill light, or even slightly less. Again try to keep distance of the strobe equal to the main and fill lights to ensure equal distribution.


5.

Understanding Studio Lighting

1. Hang your backdrop. If you are using a news, paper or much good the naked wall, decide what you backdrop is going to be, then position the Chair four to five feet in front of your backdrop. Starting here Testament administer you the target To erect your brilliance setup all over where your subject will be.