A accepted drafting table is besides broad and enormous to be protable.
Drafting tables are bulky and ponderous and laborious to maneuver. Sometimes the draftsman needs to endeavor in individual places and on a impermanent reason. It is extremely rigid to manage a drafting table to a universe or remote residence. You can cause a portable drafting table top that is easily moved and fix up. You can habit such a table top yet whether you keep bantam or no knowledge in less than six hours.
Instructions
1. Abbreviate a 4 by 8 foot collection of cabinet-grade plywood with a Hand-bill proverb. District the plywood on two sawhorses horizontally. Degree up from the backside 32 inches on Everyone objective and dwelling a stop.
2. Snap a chalk path along the plywood to associate the two marks. Blow the excess chalk off of the plywood and accommodation dejected masking tape along the chalk line. This will prevent splintering of the plywood.
3. Snap the chalk line once again on the premarked measurements, placing the line on top of the masking tape.
Fold the table when transporting and use it in various locations where a permanent table is not practical. Keep the two plywood pieces aligned after the cut. Do not flip or turn either piece.
5. Place heavy duty hinges along the plywood, connecting the two cut pieces. Place four hinges along the plywood, spacing them 24 inches apart. Inset the two end hinges by 4 inches. The table will now collapse and fold into a smaller, manageable section. The side with the hinges is now the bottom of the drafting table.
6. Attach two 2-by-4 boards the length of the table at the top (16-inch section) with 3-inch wood screws. This lumber will serve to lift the table slightly. Align the first 2-by-4 with the top edge of the table. Offset the second 2-by-4 by allowing it to hang over the previous piece by 2 inches, toward the bottom of the table.
Remove them when collapsing the table.8. Flip the table over to the top side.7. Cut two 2-by-4 boards to extend from the bottom of the table, across the hinged section and into the slotted 2-by-4 boards on the top. The 2-by-4 at the top that is overhung will serve as a slot for the side 2-by-4 boards to slide into. These two 2-by-4 boards will hold the table straight, keeping the hinges from collapsing.
Attach a 2-by-4 along the bottom, aligning it with the bottom edge. Use 1 1/2-inch wood screws to secure the lumber. This 2-by-4 will serve to hold paper, pencils and rulers on the table.4. Cut the plywood along the chalk line with a circular saw fitted with a blade for plywood. Put on a dust mask and safety goggles prior to cutting.
