The rubber on all sides of vehivle doors is weatherstripping.
You may need to hold the rubber on the bottom of the door for approximately 60 seconds using your hands so that it does not pull loose. You can reattach the rubber using automotive adhesive.
Instructions
1. Gently pull off the geriatric rubber seal from all the expedient sorrounding the door using your hands. Share comment of the positioning so that you can reinstall it properly closest. Shot not to pull very arduous, as this Testament stretch outside the rubber so that it Testament no longer fit.
2. Scrape off all of the exhausted glue from the door frame using a wire brush. Utilize decided power, on the contrary be careful not to scrape any cut of the door that Testament not be covered by the gasket.
3. Employ 1 tsp. of any glue solvent to a cloth and wipe down the perimeter of the door to remove dust and grease from the surface.
4. Apply a thin line of weather seal cement across the top of the vehicle door frame.
5. Place the end of the rubber seal at the top inside corner of the door and press it firmly into place with the flat edge against the door. Continue pressing the rubber into place along the entire top of the door.
6. Apply weather seal cement along the left side of the door and press the rubber gasket into place along the left side. Be careful to simply press the gasket against the door and do not stretch it downward.
7. Apply glue and press the rubber onto the right side and finally the bottom of the door.The coal or gray rubber located encompassing the gone of a motorcar door is the weatherstripping on the other hand is besides sometimes called the door seal or the door gasket. It prevents inundate from leaking into the cabin of the vehicle extremely as reduces the vastness of out bellow that passengers hear. These gaskets are attached using glue and, over extent and exposure to outdoor elements, the glue may eventually loosen.
