This is a pleasant lot of in fashion Craft duty that Testament literally fabricate a statement. The bonus is the low expenditure and it's and a alert Craft project that doesn't wish big league skill or expensive tools. Produce a statement with your own sui generis in fashion Craft job.
Instructions
1. Prepare the plywood for this happening Craft grindstone by sanding the surface fit. Round over the edges slightly with the sandpaper. Clean with a damp cloth and let dry. Application painters tape under the backside of the top row for accuracy.3. Cut around the letters for the art work ensuring adhesive backing remains in place.
Three rows were stressed on the portion of plywood shown. Sanction 3" heighth for Everyone of the lettered rows in this current Craft and subtract 9" from the complete heighth of the wood. Utilize the remaining inches to figure Identical spacing of top and backside margins and in between rows. Point lines lightly with the pencil. Count the figure of letters and contents in the phrase to system how many horizontal lines Testament be needed.2. Appliance the t-square ruler to end even horizontal lines across the wood.
Do a rough layout of the lettering for this contemporary piece before figuring the approximate spacing between the letters and words. Note the spacing on any sign will vary, depending on the phrasing, the size of the sign and the letters.
4. Beginning at the top row, pull off the adhesive backing and apply the first letter of the first word and the last letter of the last word. This process makes the application easier. Position the remaining letters on the first line and continue.
5. Run your fingers along the vinyl letters of the contemporary art work and press to ensure a good adhesion before continuing. This is done to lessen bleeding under the letters when the finish is applied.
6. Slide the sandwich bag over your painting hand to prevent staining the skin. Pour a little polycrylic into a clean, recycled plastic container. Add a few drops of fabric dye and gently stir until any lumps are dissolved. Do not shake the mix or stir vigorously as air bubbles will develop and may alter the finish.
7. Apply a thin coating of the polycrylic mixture onto the top of the plywood first and continue on all four sides. Keep the coating thin. Allow to dry well.
8. Remove the vinyl letters from the statement piece by pulling them off in the direction of the woodgrain to avoid splintering. Hang the contemporary art work or lean against a wall wherever you wish to make a statement.
